The usage of Bricks or Pavers to create a sidewalk or patio complements a house in a way that is unequaled. In addition, setting up a Brick or Paver pathway does not necessarily require a pro.
The secret to installing a Brick or Paver Walkway is to first effectively prepare the location where the bricks/pavers are to be installed. The location ought to be dug out a minimum of a foot down, eliminating all topsoil and clay soil. In addition, string lines should be strung on each side of the sidewalk. The string lines show the completed height of the walkway.
Once the area has actually been dug down, 3/4" gravel stone need to be laid in and tamped down tightly. The height in between the tamped down sand and the stringline ought to equate to the thickness of the brick or paver.
Now that you have a steady base, place a 1" pipe or journal board the length of the pathway on either side of the walkway. Then using a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will produce a level area to lay the bricks/pavers.
Now put on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared area. These strips will function as your pathway border and help to keep the integrity and shape of the sidewalk. You can get these plastic strip borders at a lot of house enhancement shops. The strips must be anchored down with 12" galvinized nails. You ought to sink these nails into the ground and through the strips every foot.
The secret to laying the bricks/pavers is to make sure that they interlock with each other. Always stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This here will again help keep the stability of the walkway.
Undoubtedly bricks/pavers will require to be cut or split when building the sidewalk. To really cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the area where you desire to break the brick. If your sidewalk has curves you will need to buy/rent a wetsaw.
After installing the bricks, develop the outside edges with extra sand, and then shovel in the topsoil and load down strongly.
Spread stone dust over the brand-new walkway and sweep into the cracks. This will complete the interlocking of the bricks and assist to eliminate any weed growth.
In addition, setting up a Brick or Paver sidewalk does not always need a pro. The key to setting up a Brick or Paver Walkway is to first correctly prepare the area where the bricks/pavers are to be set up. Now that you have a stable base, position a 1" pipeline or journal board the length of the walkway on either side of the walkway. These strips will act as your walkway border and help to maintain the stability and shape of the sidewalk. Inevitably bricks/pavers will need to be cut or divided when developing the walkway.